steel sheet fabrication.Aluminum alloy die casting mold use process

　　In the process of aluminum alloy die casting, a set of high-life aluminum alloy die casting mold can not only save production costs, but also improve production efficiency and product quality!

　　During the use of aluminum alloy die casting mold, the following points should be noted:

　　1. When preheating, the starting fire should not be too strong, it should be gradually increased, and it should be heated in the state of closing. When preheating, remove or block the parts that are not suitable for baking on the mold, such as sliders, springs, etc

　　2. During the test process, try not to change several parameters when the technical parameters change, otherwise it is impossible to determine which parameter has an impact on it.

　　3. During the debugging process, the pressure should be gradually increased, and too much increase may cause sticky mold, or the obtained parameter pressure is too high.

　　4. When the adhesive mold appears and the casting is difficult to take out, use wood or copper rod to clean it. It is strictly prohibited to beat with steel tools, otherwise the mold will be damaged.

　　5.

　　If the mold or other reasons, determine that they can not handle, to take the mold down, by a professional mold master to deal with.

　　6. Before use, that is, each die casting money, be sure to clean up the residual peak and debris on the surface of the mold as far as possible, otherwise it will damage the mold, resulting in casting peak and even flying.

　　7. In the process of use, the active parts should be lubricated regularly.

　　8. Mold work should be repaired for a certain time

　　9.; The cooling water flow should be set according to the unknown flow rate to adjust the overall temperature.

　　10 Replace the wearing parts regularly to ensure the quality of the casting

　　11. Mold should be regularly maintained and maintained

Read recommendations:

LED Cold Forged Radiator

aluminum channel extrusions

Automotive Mechanical Parts

Solution to Shrinkage in Aluminum Alloy Die Castings

aluminium instrument enclosure